Miller Electric A.B.B. Robot Interface Gas Control Hub And Spindle Manuel du propriétaire télécharger pdf (Page 20)

OM-884 Page 16

2-12. Hub Assembly Installation

ST-126 870-A

1 Spool Support

2 Hub Support Shaft

3 Retaining Ring

4 Hub Assembly

5 Brake Washer

6 Fiber Washer

7 Hex Nut

Install hub assembly as shown.

Tighten hex nut until a slight drag is

felt while turning hub.

Tools Needed:

9/16 in

2-13. Installing Spool-Type Wire And Adjusting Hub Tension

ST-161 001

1 Retaining Ring

2 Wire Spool

3 Hole In Spool

4 Hub

Remove retaining ring and slide

spool onto hub. Turn spool until hub

pin fits hole in spool. Reinstall re-

taining ring.

5 Tension Adjustment Nut

Grasp spool in one hand and turn

while using a wrench to adjust hex

nut. When a slight force is needed

to turn spool, tension is set.

Tools Needed:

9/16 in

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Pas de commentaire

Miller Electric A.B.B. Robot Interface Gas Control Hub And Spindle Manuel du propriétaire Page 20