Miller-electric Remote Operator Interface Manuel d'utilisateur télécharger pdf (Page 19)

OM-217 834 Page 15

General Terms:

Sequence Selecting Sequence will allow setting of preflow, start, crater, and postflow times and parameters.

Preflow Setting a time value for gas flow prior to arc start.

Start Provides voltage/arc adjust, wire feed rate, and time value for modified arc starts (which is only

adjustable with the optional PDA with File Management/WaveWriter software).

Crater Allows setting of voltage/arc adjust, wire feed rate, and time value for arc ends.

Postflow Setting a time value for gas flow after arc end.

Feeder Set Up Allow selection of Sequence and trigger functions.

Auto Thread Method of jogging wire without holding jog or trigger switch. Pressing Jog and Retract simultaneously

will automatically feed wire. Default setting is 192 at a feed rate of 700 ipm (these values can be

changed using a PDA with File Management/WaveWriter software). Pressing jog, purge, or trigger

switch will terminate the auto-threading feature.

5-2. Power Switch

1 Power Switch

803 694-A

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Pas de commentaire

Miller-electric Remote Operator Interface Manuel d'utilisateur Page 19