Miller Electric Dimension 1000 Manuel d'utilisateur télécharger pdf (Page 31)

OM-2223 Page 27

6-3. Troubleshooting

Trouble Remedy

No weld output; unit completely

inoperative; pilot light PL1 off.

Place line disconnect device in On position (see Section 4-14).

Check for open line fuse(s), and replace if open (see Section 4-14).

Check for proper input power connections (see Section 4-14).

Check for proper jumper link position (see Section 4-14).

Check fuse F1, and replace if necessary (see Section 6-2).

No weld output; pilot light PL1 on. Unit overheated. Allow unit to cool with fan On (see Section 4-2).

If using remote control, place Output (Contactor) switch in Remote 14 position, and connect remote

control (see Sections 4-10 and 4-11). If remote is not being used, place switch in On position (see

Section 5-1).

Check, repair, or replace remote control.

No weld output; power switch pilot light

on; fan off

Check for proper input power connections (see Section 4-14).

on; fan off.

Check for open line fuse(s), and replace if open, or reset circuit breaker (see Section 4-14).

Turn power switch off then back on. If no output condition remains, have Factory Authorized Service

agent check SCR’s.

Limited weld output and low

open circuit voltage

Check position of Remote Amperage/Voltage Control switch (see Section 5-1).

open-circuit voltage.

Check for open line fuse(s), and replace if open (see Section 4-14).

Check for proper input power connections (see Section 4-14).

Check for proper jumper link position (see Section 4-14).

Clean and tighten all weld output connections.

Unit provides only maximum or

minimum weld output

Have Factory Authorized Service Agent check control board PC1 and hall device HD1.

minimum weld output.

Check position of Remote Amperage/Voltage Control switch (see Section 5-1).

Erratic or improper weld output. Use proper size and type of weld cable (see Section 4-9).

Clean and tighten all weld connections.

Check wire feeder installation according to Owner’s Manual.

Check position of Process selector switch (see Section 5-1).

Have Factory Authorized Service Agent check control board PC1 and hall device HD1.

No 115 volts ac output at duplex recep-

tacle, Remote 14 receptacle,

or terminal strip 1T.

Reset circuit breaker CB1 (see Section 4-7).

No 24 volts ac output at Remote 14 re-

ceptacle or terminal strip 1T.

Reset circuit breaker CB2 (see Section 4-7).

Fan not operating. Note: fan only runs

when cooling is necessary

Check for and remove anything blocking fan movement.

when cooling is necessary.

Have Factory Authorized Service Agent check fan motor.

Wandering arc; poor control of arc

direction

Reduce gas flow rate.

direction.

Select proper size tungsten.

Properly prepare tungsten.

Tungsten electrode oxidizing and not

remaining bright after conclusion of

Shield weld zone from drafts.

rema

conc

weld.

Increase postflow time.

Check and tighten all gas fittings.

Properly prepare tungsten.

Check for water in torch, and repair torch if necessary. See torch Owner’s Manual.

Digital meter not working properly. Have Factory Authorized Service Agent check control board PC1 and connections, and replace if

necessary.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Miller Electric Dimension 1000 Manuel d'utilisateur Page 31

Commentaires sur ces manuels

Produits connexes et manuels pour Système de soudage Miller Electric Dimension 1000