Miller Electric T60 Manuel de l'opérateur télécharger pdf (Page 28)

getting started

Synrad Firestar t-Series operator’s manual

Mounting the RF power supply

The Mounting the RF power supply section includes subsections:

■ Mounting guidelines

■ Attaching mounting brackets

■ Mounting the RF supply

The RF power supply is shipped with its mounting brackets removed. Follow the steps described below to

attach mounting brackets and fasten the RF supply to your mounting surface.

Mounting guidelines

■Mount water-cooled RF power supplies vertically, or on a vertical surface, to prevent condensation

from pooling on upper or lower covers and dripping onto electrical components.

■Outline and mounting dimensions for both RF-600 and the RF-800 RF power supplies are identical;

the RF-1000 RF power supply has a slightly larger footprint.

■The RF power supply must be mounted within cable length, approximately 6 feet (2 meters), of the

Laser Head.

■When mounting RF power supplies vertically using the optional 8–32 UNC threaded holes (on the

ends of the heatsink chassis), the RF power supply must be supported on both upper and lower ends.

■To ensure optimum system performance, t-Series Laser Heads and RF power supplies are tested and

shipped as matched sets. Interchanging these components may result in decreased laser performance.

RF cables may be interchanged as long as the cable length is identical.

■Air- or fan-cooled units must have at least 2.25" (57.2 mm) of unobstructed clearance between the

outside edge of the cooling fan housing and any enclosure or mounting surface to allow for proper

airﬂow.

Attaching mounting brackets

To attach RF mounting brackets, refer to Figure 1-2 and perform the following steps:

Figure 1-2 Attaching mounting brackets

–

RF OUT

LASER

USER I/O

OFF

LASE

INT

TMP

RDY

SHT

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 133 134

Pas de commentaire

Miller Electric T60 Manuel de l'opérateur Page 28